Making an isometric drawing autocad1/3/2023 Rest of the process is same as mentioned above. You can directly start isometric drawing using ISODRAFT option of the status bar.Ĭlick on ISODRAFT icon on the status bar as shown in the image above and select plane on which you want to create your drawing by pressing F5 key. With AutoCAD 2015 and later versions, this process of creating an isometric drawing has been greatly simplified. Isometric drawing in AutoCAD 2015 and later versions: In a similar way, you can make other isometric drawings as well. Start line command again and make lines from three corners of the square of length 5 units towards downward direction as shown in the image B above.Īgain change Isoplane to Top by pressing F5 key and join all three end points of the vertical lines to make a complete cube. Now press F5 again to change the Isoplane to right or left. Specify a direction and type 5 on the command line then press enter, repeat this process by changing directions of line to make a closed square as shown in image A below. Press F5 key to activate Isoplane top and then select line command and click anywhere in the drawing area to start your line. The three Isoplanes available for selection are Isoplane top, right and left. You can now select isometric plane for your drawing by pressing the F5 key. Now make sure ortho mode is turned on from the status bar, if it is not turned on then press F8 to turn it on. Click OK to exit drafting settings window. Type DS on the command line and press enter.ĭrafting settings window will pop up from this window select snap and grid tab and make sure Isometric snap radio button is checked. Isometric drawing in AutoCAD 2014 and older versions:Īt first, you need to change your snap settings to isometric.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |